Instructions for inserting picture into FOREVERframe

To insert your own special photo into FOREVERframe:

  • Select picture you wish to use….can be an original photo with an image actual size of frame opening (approx. 5/8’ square) or a printed copy reduced to size. Paper should not be thicker than standard photo paper.

  • Remove crystal window from the FOREVERframe.

  • Place crystal over picture you plan to use.

  • Trace around crystal with pen or pencil so that image is close to actual size of crystal.

  • Cut slightly inside the traced line with scissors or exacto knife

  • Photo should not be larger than the crystal.
  • Place photo under crystal.

  • Hold frame sideways, not upright, and insert crystal and photo together into opening on top of frame. If photo does not fit properly it may be too large. Trim off small slice, carefully, until picture is sized.

  • Space is tight to prevent slippage, however, some thinner pictures may need another piece of paper, same size, to tighten the fit….so adjust accordingly.

To remove and change picture:

  • Hold sideways. Gold back has a small notch at top center.

  • Use a pin…..insert in notch and pull out gently.

Photo should slide out easily. FOREVERframe does not have a watertight seal. Make sure you remove necklace before bathing or swimming. Clean as you would any other fine jewelry.